Dell Embedded Box PC5000 - Removing the Top Cover; Prerequisites; Procedure

Removing the top cover
WARNING: Before working inside your Embedded Box PC, read the safety
information that shipped with your Embedded Box PC and follow the steps
in Before working inside your Embedded Box PC. After working inside your
Embedded Box PC, follow the steps in After working inside your Embedded
Box PC. For more safety best practices, see the Regulatory Compliance
home page at www.dell.com/regulatory_compliance.
Prerequisites
1 Follow step 1 to step 6 in “Removing the back cover”.
2 Remove the PCI/PCIe card (if installed).
3 Remove the CANbus cable.
4 Remove the riser card.
5 Remove the power connectors.
Procedure
1 Disconnect the power-switch cable and remove it from the routing guides on the
chassis.
109