Dell Embedded Box PC5000 - Removing the Canbus Card; Prerequisites; Procedure

Removing the CANbus card
WARNING: Before working inside your Embedded Box PC, read the safety
information that shipped with your Embedded Box PC and follow the steps
in Before working inside your Embedded Box PC. After working inside your
Embedded Box PC, follow the steps in After working inside your Embedded
Box PC. For more safety best practices, see the Regulatory Compliance
home page at www.dell.com/regulatory_compliance.
Prerequisites
1 Follow step 1 to step 6 in “Removing the back cover”.
2 Remove the PCI/PCIe card (if installed).
Procedure
NOTE: Embedded Box PC is shipped with a combination of WWAN, WLAN,
or CANbus card depending on the conguration ordered.
1 Disconnect the CANbus cable from the connector on the CANbus card.
2 Remove the screws that secure the CANbus card to the system board.
80