Dell Embedded Box PC5000 - Replacing the Interposer Board; Procedure; Post-Requisites

Replacing the interposer board
WARNING: Before working inside your Embedded Box PC, read the safety
information that shipped with your Embedded Box PC and follow the steps
in Before working inside your Embedded Box PC. After working inside your
Embedded Box PC, follow the steps in After working inside your Embedded
Box PC. For more safety best practices, see the Regulatory Compliance
home page at www.dell.com/regulatory_compliance.
Procedure
1 Align the screw holes on the interposer board with the screw holes on the solid-
state drive card bracket.
2 Replace the screws that secure the interposer board to the solid-state drive card
bracket.
Post-requisites
1 Replace the solid-state drive in to bracket.
2 Replace the drives in to the hard-drive cage.
3 Follow step 2 to step 8 in “Replacing the back cover”.
36