Removing the Dell logo board
WARNING: Before working inside your Embedded Box PC, read the safety
information that shipped with your Embedded Box PC and follow the steps
in Before working inside your Embedded Box PC. After working inside your
Embedded Box PC, follow the steps in After working inside your Embedded
Box PC. For more safety best practices, see the Regulatory Compliance
home page at www.dell.com/regulatory_compliance.
Prerequisites
1 Follow step 1 to step 6 in “Removing the back cover”.
2 Remove the PCI/PCIe card (if installed).
3 Remove the WLAN-antenna connectors.
4 Remove the WLAN card.
5 Remove the WWAN-antenna connectors.
6 Remove the CANbus card or WWAN card.
7 Remove the SIM card.
8 Remove the intrusion switch.
9 Remove the bottom cover.
10 Remove the memory module.
11 Remove the heat sink.
12 Remove the riser card.
13 Remove the power connectors.
14 Follow step 1 to step 4 in Removing the top cover.
15 Remove the CPU board.
128
To Next Page
Loading...
Need help?
General
