Replacing the WLAN-antenna
connectors
WARNING: Before working inside your Embedded Box PC, read the safety
information that shipped with your Embedded Box PC and follow the steps
in Before working inside your Embedded Box PC. After working inside your
Embedded Box PC, follow the steps in After working inside your Embedded
Box PC. For more safety best practices, see the Regulatory Compliance
home page at
www.dell.com/regulatory_compliance.
Procedure
1 Insert the WLAN-antenna connectors into the WLAN-antenna connector slots
on the bottom cover.
NOTE: Insert the WLAN-antenna connectors based on the color
indicated behind the bottom cover.
2 Replace the nuts and washers that secure the WLAN-antenna connectors to the
bottom cover.
3 Route the WLAN-antenna cables through the routing guides on the chassis.
4 Connect the WLAN-antenna cables to the WLAN card.
The following table provides the antenna-cable color scheme for the WLAN card
supported by the Embedded Box PC.
Connectors on the WLAN card
Antenna-cable color
Main (white triangle) White
Auxiliary (black triangle) Black
Post-requisites
1 Replace the PCI/PCIe card (if necessary).
2 Follow step 2 to step 8 in “Replacing the back cover”.
58
To Next Page
Loading...
Need help?
General
