Dell Embedded Box PC5000 - Replacing the Canbus Cable; Procedure; Post-Requisites

Replacing the CANbus cable
WARNING: Before working inside your Embedded Box PC, read the safety
information that shipped with your Embedded Box PC and follow the steps
in Before working inside your Embedded Box PC. After working inside your
Embedded Box PC, follow the steps in After working inside your Embedded
Box PC. For more safety best practices, see the Regulatory Compliance
home page at www.dell.com/regulatory_compliance.
Procedure
1 Place the CANbus port into the CANbus slot on the top cover.
2 Replace the hexagonal screws that secure the CANbus port to the top cover.
3 Route the CANbus cable through the routing guides on the chassis and under
the heat sink plate.
4 Connect the CANbus cable to the connector on the CANbus card.
Post-requisites
1 Replace the PCI/PCIe card (if necessary).
2 Follow step 2 to step 8 in “Replacing the back cover”.
79