Figure 19. Installing the PERC battery
Next steps
1. If disconnected, connect the battery cable to the PERC card.
2. Follow the procedure listed in After working inside your system.
Air shroud
Removing the air shroud
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. If applicable, disconnect the battery cable from the PERC card.
Steps
1. Press the clip on the air shroud to release the shroud from the sled.
2. Remove the shroud by rotating the shroud and releasing the hinge from the slot on the system.
28
Installing and removing enclosure components
To Next Page
Loading...
