Figure 54. Installing the M.2 SATA x16 riser
Next steps
1. Follow the procedure listed in After working inside your system.
Removing the M.2 SATA card
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. If applicable, remove the expansion card riser assembly.
4. Remove the M.2 x16 riser or install the M.2 SATA x8 mezzanine card.
NOTE: The procedure to remove the M.2 SATA x8 mezzanine card is similar to removing a mezzanine card.
Steps
1. Using the Phillips #1 screwdriver, unscrew the screw that secures the M.2 card to the board.
2. Pull the card out of the connector and lift the card away.
64
Installing and removing enclosure components
To Next Page
Loading...
