Figure 46. Installing the expansion card riser assembly
Next steps
1. Follow the procedure listed in After working inside your system.
Removing an expansion card
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. Remove the expansion card riser assembly.
Steps
1. Remove the screw that secures the expansion card to the assembly.
2. Hold the expansion card by its edges, and carefully remove it from the riser card.
NOTE:
Install an expansion card filler bracket over an empty expansion slot to maintain Federal Communications
Commission (FCC) certification of the system. The brackets also keep dust and dirt out of the system and aid in proper
cooling and airflow inside the system.
Installing and removing enclosure components 57
To Next Page
Loading...
