Figure 52. Installing the riser card
Next steps
1. If removed, install the expansion card.
2. Install the expansion card riser assembly.
3. Follow the procedure listed in After working inside your system.
Removing the M.2 SATA x16 riser
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure listed in Before working inside your system.
Steps
1. Using the Phillips #1 screwdriver, loosen the screw that secures the riser to the sled.
2. Lift the riser up to disengage the riser from the connector on the system board.
3. Disconnect the data cable from the riser.
62
Installing and removing enclosure components
To Next Page
Loading...
