Figure 57. Installing the M.2 SATA card on the SATA x16 riser
Figure 58. Installing the M.2 SATA card on the SATA x8 mezzanine card
Next steps
1. If removed, install the expansion card riser assembly.
2. Install the M.2 x16 riser or install the M.2 SATA x8 mezzanine card.
NOTE: The procedure to install the M.2 SATA x8 mezzanine card is similar to installing a mezzanine card.
3. Follow the procedure listed in After working inside your system.
M.2 SSD module
The BOSS card is a simple RAID solution card designed specifically for booting a server's operating system. The card supports
up to two 6 Gbps M.2 SATA drives. The BOSS adapter card has a x8 connector using PCIe gen 2.0 x2 lanes, available only in the
low-profile and half-height form factor.
66
Installing and removing enclosure components
To Next Page
Loading...
