Figure 101. Installing the power interposer board
Next steps
1. Connect the cables to the PIB and route them properly.
2. Install the PSU.
3. Install the air shroud.
4. Follow the procedure listed in After working inside your system.
Cooling fan cage board
Removing the cooling fan cage board
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. Remove the following components:
a. Air shroud
b. Cooling fan cage assembly
4. Disconnect cables from the fan board.
Steps
1. Using a Phillips #2 screwdriver. remove the screws that secures the fan board to the system.
2. Holding the edges lift the fan board out of the system.
102
Installing and removing system components
To Next Page
Loading...
