Dell EMC PowerEdge R550 - Installing the BOSS S2 Module

Figure 78. Removing the BOSS cover
Next steps
1. Replace the BOSS S2 module.
Installing the BOSS S2 module
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. If required, remove the air shroud.
Steps
1. Slide the BOSS cover on the BOSS S2 module. Using the Phillips #1 screwdriver, secure the BOSS cover on the BOSS S2
module with the M3 x 0.5 x 4.5 mm screw.
Installing and removing system components
83