Next steps
1. Install the OCP shroud.
2. Follow the procedure listed in After working inside your system.
System battery
This is a service technician replaceable part only.
Replacing the system battery
Prerequisites
WARNING:
There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery only
with the same or equivalent type recommended by the manufacturer. Discard used batteries according to the
manufacturer's instructions. See the Safety instructions that came with your system for more information.
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. If required, move aside the cable that pass over the battery.
Steps
1. To remove the battery:
a. Use a plastic scribe to pry out the system battery.
92
Installing and removing system components
To Next Page
Loading...
