Dell EMC PowerEdge R550 - Removing the OCP Card

Next steps
1. Follow the procedure listed in After working inside your system.
Removing the OCP card
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. Remove the OCP shroud.
Steps
1. Open the blue latch to disengage the OCP card.
2. Push the OCP card towards the rear end of the system to disconnect from the connector on the system board.
3. Slide the OCP card out of the slot on the system.
90
Installing and removing system components