2. Follow the procedure listed in the Before working inside your system.
Steps
1. Connect the USB key to the internal USB card.
NOTE: For information on the exact location of USB on system board, see System board jumpers and connectors
section
2. Align the internal USB card with the connector on the system board and press firmly until the internal USB card is seated.
Figure 93. Installing the internal USB card
Next steps
1. Follow the procedure listed in After working inside your system.
2. While booting, press F2 to enter System Setup and verify that the system detects the USB memory key.
MicroSD card
Removing the MicroSD card
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. Remove the IDSDM module.
Steps
1. Locate the MicroSD card slot on the IDSDM module, and press the card to partially release it from the slot. For more
information on the slot location, see System board jumpers and connectors section.
2. Hold the MicroSD card and remove it from the slot.
NOTE: Temporarily label each MicroSD card with its corresponding slot number after removal.
Installing and removing system components 95
To Next Page
Loading...
