NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 69. Installing the filler bracket
Next steps
Replace the expansion card.
Installing the expansion card
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. If required, remove the air shroud.
Steps
1. Rotate to open the PCIe card holder.
2. If Installed, lift the metal filler bracket from the system.
NOTE:
Store the riser blanks for future use. Filler brackets must be installed in empty expansion card slots to maintain
Federal Communications Commission (FCC) certification of the system. The brackets also keep dust and dirt out of the
system and aid in proper cooling and airflow inside the system.
Installing and removing system components 77
To Next Page
Loading...
