Dell EMC PowerEdge R550 - Optional Serial COM Port; Removing the Optional Serial COM Port

Figure 33. Installing the intrusion switch
Next steps
1. Connect the system power cable to the system board.
2. Install the air shroud.
3. Follow the procedure listed in After working inside your system.
Optional serial COM port
This is a service technician replaceable part only.
Removing the optional serial COM port
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
Steps
1. Disconnect the serial COM port cable from the connector on the system board.
NOTE: Observe the routing of the cable as you remove it from the system.
2. Open the card holder and lift the serial COM port out of the system.
Installing and removing system components
45