Figure 85. Installing the front mounting front PERC module
Next steps
1. Connect the PERC cables to the backplane and system board connectors.
2. Install the cooling fan cage assembly.
3. Install the drive backplane cover.
4. Install the air shroud.
5. Follow the procedure listed in After working inside your system.
Optional OCP card
Removing the OCP shroud
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
Steps
Hold the edges of the OCP shroud and lift the shroud at an angle out of the system.
88
Installing and removing system components
To Next Page
Loading...
