Figure 74. Removing the BOSS S2 card carrier
3. Using the Phillips #1 screwdriver remove the M3 x 0.5 x 4.5 mm screw that secures the M.2 SSD to the BOSS S2 card
carrier.
4. Slide the M.2 SSD out from the BOSS S2 card carrier.
Figure 75. Removing the M.2 SSD
5. Disconnect the BOSS power cable and BOSS signal cable from the system board.
NOTE: BOSS signal cable must be removed from the clips on the system board.
6. Using the Phillips #1 screwdriver remove the two M3 x 0.5 x 4.5 mm screws that secure the BOSS S2 module on the BOSS
module bay.
7. Slide out the BOSS S2 module from the BOSS module bay.
Installing and removing system components
81
To Next Page
Loading...
