Figure 41. Installing a processor
1. socket-release lever 1 2. pin–1 corner of the processor
3. processor 4. slot (4)
5. processor shield 6. socket-release lever 2
7. processor socket 8. tab (4)
Next steps
NOTE: Ensure that you install the heat sink after you install the processor. The heat sink is necessary to maintain proper
thermal conditions.
1. Install the heat sink.
2. If removed, reinstall the PCIe expansion card riser.
3. If disconnected, reconnect the cables to the expansion card(s).
4. Follow the procedure listed in the After working inside your system.
5. While booting, press F2 to enter System Setup and verify that the processor information matches the new system
configuration.
6. Run the system diagnostics to verify that the new processor operates correctly.
Related references
Safety instructions on page 67
Related tasks
Before working inside your system on page 68
Removing an expansion card from expansion card riser 2 or 3 on page 117
Removing an expansion card from the expansion card riser 1 on page 120
Removing the cooling shroud on page 75
Removing a heat sink on page 99
Installing a heat sink on page 106
Installing and removing system components 105
To Next Page
Loading...
