Dell EMC PowerEdge R730xd User Manual

Related tasks
Removing the optional front bezel on page 69
Installing the optional front bezel on page 70
Removing a 2.5 inch hard drive blank (rear)
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that came with the product.
CAUTION: To maintain proper system cooling, all empty hard drive slots must have hard drive blanks installed.
Follow the safety guidelines listed in safety instructions section.
Steps
Pull the hard drive blank out until it is free of the hard drive slot.
Figure 93. Removing and installing a 2.5 inch hard drive blank (rear)
a. hard drive blank (rear)
Related references
Safety instructions on page 67
Installing a 2.5 inch hard drive blank (rear)
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions section.
Steps
Insert the hard drive blank into the hard drive slot until it clicks into place.
Installing and removing system components 161

Dell EMC PowerEdge R730xd Specifications

General

Form Factor	2U rack server
Management	iDRAC8 with Lifecycle Controller
Processor	Intel Xeon processor E5-2600 v4 product family; Intel Xeon processor E5-2600 v3 product family
RAID Controller	PERC H330, H730, H730P, H830
Power Supply	495W, 750W, 1100W
Expansion Slots	Up to 7 x PCIe 3.0 slots: Up to 3 x full-height, full-length slots; Up to 4 x half-height, half-length slots
Operating System Support	Microsoft Windows Server, Red Hat Enterprise Linux, SUSE Linux Enterprise Server, VMware vSphere ESXi