Dell EMC PowerEdge R730xd - Removing a 1.8-Inch Hard Drive from a Hard Drive Carrier

2. If installed, remove the front bezel.
Steps
Insert the hard drive blank into the hard drive slot until the release button clicks into place.
Next steps
If applicable, install the front bezel.
Figure 104. Installing a 1.8-inch hard drive blank
1. hard drive blank
Related references
Safety instructions on page 67
Related tasks
Removing the optional front bezel on page 69
Installing the optional front bezel on page 70
Removing a 1.8-inch hard drive from a hard drive carrier
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions section.
2. Remove the hard drive carrier from the system.
Steps
1. Turn the hard drive carrier.
2. Pull the rails of the hard drive carrier and lift the hard drive out of the hard drive carrier.
Installing and removing system components 169