3. release lever (2) 4. guide pin on the system board (2)
5. cooling fan connector (6) 6. guide pin on the chassis (6)
Next steps
1. Install the cooling fan assembly.
2. Follow the procedure listed in the After working inside your system section.
Related references
Safety instructions on page 67
Related tasks
Before working inside your system on page 68
Installing the cooling fan assembly on page 89
After working inside your system on page 68
Installing the cooling fan assembly
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that are shipped with your product.
1. Follow the safety guidelines listed in Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
CAUTION: Ensure that the cables are correctly installed and retained by the cable retention bracket before
installing the cooling fan assembly. Incorrectly installed cables may get damaged.
Steps
1. Align the slots on the cooling fan assembly with the guide pins on the chassis.
2. Slide the cooling fan assembly into the chassis.
3. Lock the cooling fan assembly into the chassis by lowering the release levers until firmly seated.
Installing and removing system components 89
To Next Page
Loading...
