Figure 34. Installing the cooling fan assembly
1. cooling fan assembly 2. cooling fan (6)
3. release lever (2) 4. guide pin on the system board (2)
5. cooling fan connector (6) 6. guide pin on the chassis (6)
Next steps
Follow the procedure listed in the After working inside your system section.
Related references
Safety instructions on page 67
Related tasks
Before working inside your system on page 68
After working inside your system on page 68
System memory
The system supports DDR4 registered DIMMs (RDIMMs) and load reduced DIMMs (LRDIMMs). System memory holds the
instructions that are executed by the processor.
NOTE: MT/s indicates DIMM speed in MegaTransfers per second.
Memory bus operating frequency can be 1866 MT/s, 2133 MT/s, or 2400 MT/s depending on the following factors:
● DIMM type (RDIMM or LRDIMM)
● Number of DIMMs populated per channel
● System profile selected (for example, Performance Optimized, Custom, or Dense Configuration Optimized)
● Maximum supported DIMM frequency of the processors
90 Installing and removing system components
To Next Page
Loading...
