Figure 73. Installing the NDC
1. captive screw socket (2) 2. connector on the system board
3. captive screw (2) 4. touch point (2)
5. network daughter card (NDC) 6. back panel slot for Ethernet connectors
Next steps
1. If applicable, install the expansion card(s) in the expansion card riser 2.
2. Follow the procedure listed in the After working inside your system section.
Related references
Safety instructions on page 67
Related tasks
Before working inside your system on page 68
Removing an expansion card from expansion card riser 2 or 3 on page 117
Installing an expansion card into the expansion card riser 2 or 3 on page 118
After working inside your system on page 68
Internal USB memory key (optional)
An optional USB memory key installed inside your system can be used as a boot device, security key, or mass storage device.
To boot from the USB memory key, configure the USB memory key with a boot image and then specify the USB memory key in
the boot sequence in System Setup.
The internal USB port must be enabled in Internal USB Port option in the Integrated Devices screen of System Setup.
Installing and removing system components 139
To Next Page
Loading...
