Dell EMC PowerEdge R740 - Installing Riser 2 and 3 Blank

Figure 61. Removing riser 2 and 3 blank
Next steps
Install the riser 2 and 3 blank.
Related links
Removing the air shroud
Installing riser 2 and 3 blank
Installing riser 2 and 3 blank
Prerequisites
Follow the safety guidelines listed in Safety instructions.
Steps
1 Align the screw and guide rail on the riser blank with the screw hole and stando on the system.
2 Lower the blank into the system until the release tab clicks into place.
3 Tighten the screws to secure the riser blank to the system.
Dell EMC PowerEdge R740 Installation and Service Manual
Installing and removing system components
113