Dell EMC PowerEdge R740 - Removing GPU Card; Installing GPU Card

• Due to the high power consumption of GPUs, the ambient inlet temperature is restricted to 30°C for CPU 150 W/8 C, 165 W/12 C, 200
W, 205 W to ensure adequate cooling when one or more GPU cards are installed. For more information, see the ambient temperature
limitations section.
• Ensure that the GPU enablement kit is available.
The GPU enablement kit includes:
• Low prole heat sinks
• Power cables for the GPU cards
• Filler brackets with closeout EMI shield for unoccupied PCIe slots
• All GPU cards must be of the same type and model.
• You can install up to three double-wide GPU cards.
• The plastic ller bracket on the GPU air shroud must be removed before installing the GPU card.
• Ensure that high performance fans and GPU air shroud are installed.
• Ensure that your system uses the redundant 1100 W power supplies.
NOTE: When using the system with the Nvidia K80 GPU card, ensure that you install both PSUs with a minimum of 1100
W each and set the PSU conguration to non-redundant mode.
Related links
Ambient temperature limitations
Removing GPU card
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
3 Remove the top cover of the GPU air shroud.
Steps
1 Lift the expansion card latch.
2 Close the PCIe card holder latch on the GPU air shroud and risers.
3 Hold the GPU card by its edges and slide out the GPU card at an angle to release it from the connector on the riser card.
4 Disconnect the cable from the GPU card.
5 If you are removing the card permanently:
a Install a metal ller bracket over the empty slot opening, and close the expansion card latch and PCIe card holder latches.
b Install a plastic ller bracket on the GPU air shroud to maintain proper air ow.
NOTE
: You must install a ller bracket over an empty expansion card slot to maintain Federal Communications
Commission (FCC) certication of the system. The brackets also keep dust and dirt out of the system and aid in proper
cooling and airow inside the system. The ller bracket is necessary to maintain proper thermal conditions.
Next steps
Install the GPU card.
Related links
Opening and closing the PCIe card holder latch
Installing GPU card
Installing GPU card
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
Dell EMC PowerEdge R740 Installation and Service Manual
Installing and removing system components
123