Dell EMC PowerEdge R740 - Removing Riser 3 Blank

Figure 62. Installing riser 2 and 3 blank
Next steps
1 Install the air shroud.
2 Follow the procedure listed in After working inside your system.
Related links
Installing the air shroud
Removing riser 3 blank
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
Steps
1 Using Phillips #2 screwdriver, loosen the screw that secures the blank to the system.
2 Lift the blank away from the system.
114
Dell EMC PowerEdge R740 Installation and Service Manual
Installing and removing system components