Figure 77. Removing integrated storage controller cable
3 Lift one end of the card and angle it to disengage the card from the integrated storage controller card holder on the system board.
4 Lift the card out of the system.
5 Hold the interposer board by its edges, and pull the board until the connector on the board disengages from the connector on the
system board.
Figure 78. Removing integrated storage controller card
Next steps
Install the integrated storage controller card.
Related links
Removing the air shroud
Removing expansion card riser 1
Installing integrated storage controller card
130
Dell EMC PowerEdge R740 Installation and Service Manual
Installing and removing system components
To Next Page
Loading...
