Dell G5 5587 - 22 Replacing the Status-Light Board; Procedure; Post-Requisites

Identifier GUID-9688293F-8D74-48E4-A8DD-4696624BAD12
Status Released
Removing the computer base
WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before working inside your computer. After working inside your computer, follow the instructions in After working inside
your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Topics:
• Prerequisites
• Procedure
Identifier GUID-6367EA32-44DD-4661-AB55-653C60D0EC34
Status Released
Prerequisites
1 Remove the base cover.
2 Remove the battery.
3 Remove the rear cover.
4 Remove the wireless card.
Identifier GUID-5F7062C1-0AE2-4FA0-A6BE-89039267011D
Status Released
Procedure
1 Using pull tab, disconnect the camera cable from the system board.
2 Peel the camera cable o the computer base.
3 Remove the antenna cables from the routing guides on the computer base.
4 Remove the screw (M2x3) that secures the display-cable bracket to the computer base.
5 Lift the display-cable bracket o the computer base.
6 Using the pull tab, disconnect the display cable from the system board.
7 Remove the display cable from the routing guides on the computer base and peel the display cable o the computer base.
19
44 Removing the computer base