6 Connect the speaker cable to the system board.
7 Align and place the USB Type-C port bracket on the system board.
8 Replace the two screws (M2.5x5) that secure the USB Type-C port bracket to the computer base.
9 Align and place the power-adapter port bracket on the computer base.
10 Replace the two screws (M2.5x5) that secure the power-adapter port bracket to the computer base.
11 Turn the computer base over.
12 Connect the power-adapter port cable to the system board.
13 Slide the status-light board cable into the connector on the system board and close the latch to secure the cable.
14 Slide the hard-drive cable into the connector on the system board and close the latch to secure the cable.
15 Connect the coin-cell battery to the system board.
64
Replacing the system board
To Next Page
Loading...
