Dell G5 5587 - 42 Replacing the Palm Rest; Procedure; Post-Requisites

Identifier GUID-FBA68EE4-1E13-4F28-9B84-362694B97060
Status Released
Replacing the power-button board
WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before working inside your computer. After working inside your computer, follow the instructions in After working inside
your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Topics:
• Procedure
• Post-requisites
Identifier GUID-A96E571E-8CCC-4AD0-ADD4-3C7F777D72CF
Status Released
Procedure
1 Align the screw holes on the power-button board with the screw holes on the palm-rest assembly.
2 Replace the two screws (M2x3) that secure the power-button board to the palm-rest assembly.
3 Slide the ngerprint-reader board cable into the connector on the ngerprint-reader board and close the latch to secure the cable.
4 Adhere the power-button board cable to the palm-rest assembly.
5 Adhere the tape that secures the ngerprint-reader board and the power-button board to the palm-rest assembly.
32
76 Replacing the power-button board