Dell G5 5587 - 28 Replacing the Power-Adapter Port; Procedure; Post-Requisites

Identifier GUID-8EDA8A82-09F4-420D-8DE0-82220E44E1C2
Status Released
Replacing the status-light board
WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before working inside your computer. After working inside your computer, follow the instructions in After working inside
your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Topics:
• Procedure
• Post-requisites
Identifier GUID-CD061A12-AE04-4335-A3EE-01D6E65E4A6C
Status Released
Procedure
1 Align the screw holes on the status-light board with the screw holes on the computer base.
2 Replace the screw (M2x3) that secures the status-light board to the computer base.
3 Slide the status-light board cable into the connector on the status-light board and close the latch to secure the cable.
22
54 Replacing the status-light board