Dell Inspiron 13 7000 - 26 Replacing the status-light board

Replacing the status-light board
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer. After working inside your computer, follow the instructions in After
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Topics:
• Procedure
• Post-requisites
Procedure
1. Align and place the status-light board in the slot on the palm-rest assembly.
2. Adhere the foam securing the status-light board to the palm-rest assembly.
3. Slide the status-light board-cable into the connector on thesystem board and close the latch to secure the cable.
Post-requisites
1. Replace the battery.
2. Replace the base cover.
26
46 Replacing the status-light board