Removing the camera
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer. After working inside your computer, follow the instructions in After
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Topics:
• Prerequisites
• Procedure
Prerequisites
1. Remove the base cover.
2. Remove the battery.
3. Remove the display assembly.
4. Follow the procedure from step 1 to step 3 in “Removing the display panel”.
Procedure
CAUTION: Place the display-panel assembly on a soft and clean surface to avoid scratching the display.
1. Using a plastic scribe, pry the camera module off the display panel.
2. Turn the camera over and peel off the tape to disconnect the camera cable from the camera module.
Figure 35. Removing the camera
1.
display panel 2. plastic scribe
43
74 Removing the camera
To Next Page
Loading...
