Replacing the display cable
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer. After working inside your computer, follow the instructions in After
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Topics:
• Procedure
• Post-requisites
Procedure
1. Route the display cable through the routing guides on the display panel.
2. Slide the display cable into the connector and press down the latch to secure the cable.
3. Slide the sensor-board cable into the connector on the sensor board and press down the latch to secure the cable.
4. Adhere the sensor-board cable tape.
5. Adhere the tape that secures the display cable to the display panel.
Post-requisites
1. Follow the procedure from step 4 to step 6 in “Replacing the display panel”.
2. Replace the display assembly.
3. Replace the camera.
4. Replace the battery.
5. Replace the base cover.
46
Replacing the display cable 79
To Next Page
Loading...
