Replacing the display assembly
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer. After working inside your computer, follow the instructions in After
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Topics:
• Procedure
• Post-requisites
Procedure
CAUTION: Place the computer on a soft and clean surface to avoid scratching the display.
1. Place the display assembly face down on the palm-rest assembly.
2. Align the screw holes on the display hinges with the screw holes on the palm-rest assembly.
3. Replace the four screws (M2.5x2.5 Big Head) that secure the display assembly to the palm-rest assembly.
4. Close the display and turn the computer over.
5. Slide the display cable and the touch-screen board-cable into their respective connectors on the system board and close the
latches to secure the cables.
6. Adhere the pieces of tape that secure the display cable and the touch-screen board-cable to their respective connectors on
the system board.
Post-requisites
1. Replace the wireless card.
2. Replace the battery.
3. Replace the base cover.
32
Replacing the display assembly 55
To Next Page
Loading...
