Removing and installing components
NOTE: The images in this document may differ from your computer depending on the configuration you ordered.
Recommended tools
The procedures in this document may require the following tools:
● Phillips screwdriver #0
● Plastic scribe
Screw list
NOTE: When removing screws from a component, it is recommended to note the screw type, the quantity of screws, and
then place them in a screw storage box. This is to ensure that the correct number of screws and correct screw type is
restored when the component is replaced.
NOTE: Some computers have magnetic surfaces. Ensure that the screws are not left attached to such surfaces when
replacing a component.
NOTE: Screw color may vary with the configuration ordered.
Table 1. Screw list
Component Screw type Quantity Screw image
Base cover
● M2x5
● Captive screw
● 6
● 2
●
●
3-cell battery/4-cell battery M2x3 3/4
M.2 2230/2280 solid-state
drive
M2x2 1
2.5-inch hard-disk drive
2.5-inch hard-disk drive bracket
M2x3.5
M3x3
4
4
Wireless-card M2x3.5 1
2
10 Removing and installing components
To Next Page
Loading...
