Steps
1. Using a plastic scribe, pry the display panel from the bottom-right corner.
2. Using your hands, gently pry the display panel from the tabs along the right side of the display back-cover.
3. Repeat step 1 and 2 for the left side of the display panel assembly.
4. Lift the bottom side of the display panel and slide it downward to release the display brackets from the slots at the top side
of the display cover.
5. Gently flip the display panel assembly forward, peel back the Mylar tape securing the display cable on the rear of the display
panel.
NOTE: Ensure that the panel has a clean and smooth surface to rest on to prevent damage.
6. Disconnect the display cable from the display panel assembly and lift the display panel away from the system.
NOTE: Do not remove the metal brackets from the panel.
Installing the display panel
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the display panel and provide a visual representation of the installation procedure.
56
Removing and installing components
To Next Page
Loading...
