Steps
1. Using the alignment post, adhere the camera module on the display back-cover and antenna assembly.
2. Connect the camera cable to its connector on the camera module.
Next steps
1. Install the display panel.
2. Install the display hinges.
3. Install the display bezel.
4. Install the display hinge caps.
5. Install the display assembly.
6. Install the wireless card.
7. Install the base cover.
8. Install the secure digital card.
9. Follow the procedure in After working inside your computer.
Display cable
Removing the display cable
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the secure digital card.
3. Remove the base cover.
4. Remove the wireless card.
5. Remove the display assembly.
6. Remove the display hinge caps.
7. Remove the display bezel.
8. Remove the display hinges.
9. Remove the display panel.
About this task
The following image indicates the location of the display cable and provides a visual representation of the removal procedure.
60
Removing and installing components
To Next Page
Loading...
