2. Remove the screw (M2x2) and the three screws (M2x3.5) that secure the system board to the palm-rest and keyboard
assembly.
NOTE: When removing the system board with the system board thermal plate, remove the two screws (M2x5) that
secure the system board thermal plate to the palm-rest and keyboard assembly.
3. Carefully lift and remove the system board away from the palm-rest and keyboard assembly.
Installing the system board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the connectors on your system board.
66
Removing and installing components
To Next Page
Loading...
