Steps
1. Place the power button into its slot on the palm-rest and keyboard assembly.
2. Align the screw hole on the power button to the screw hole on the palm-rest and keyboard assembly.
3. Replace the screw (M2x2) to secure the power button to the palm-rest and keyboard assembly.
Next steps
1. Install the I/O daughter-board.
2. Install the display assembly.
3. Install the wireless card.
4. Install the base cover.
5. Install the secure digital card.
6. Follow the procedure in After working inside your computer.
Power button with optional fingerprint reader
Removing the power button with optional fingerprint reader
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the secure digital card.
3. Remove the base cover.
4. Remove the wireless card.
5. Remove the display assembly.
6. Remove the I/O daughter-board.
About this task
NOTE: This procedure applies only to systems shipped with a power button with optional fingerprint reader installed.
The following images indicate the location of the power button with optional fingerprint reader and provide a visual
representation of the removal procedure.
76
Removing and installing components
To Next Page
Loading...
