Steps
1. Place the I/O daughter-board flexible flat cable on the palm-rest and keyboard assembly.
2. Connect the I/O daughter-board flexible flat cable to the connector on the system board.
3. Close the latch on the I/O daughter-board flexible flat cable connector to secure it to the system board.
4. Connect the I/O daughter-board flexible flat cable to the connector on the I/O daughter-board.
5. Close the latch on the I/O daughter-board flexible flat cable connector to secure it to the I/O daughter-board.
Next steps
1. Install the base cover.
2. Install the secure digital card.
3. Follow the procedure in After working inside your computer.
I/O daughter-board
Removing the I/O daughter-board
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the secure digital card.
3. Remove the base cover.
4. Remove the wireless card.
5. Remove the display assembly.
About this task
The following images indicate the location of the I/O daughter-board and provide a visual representation of the removal
procedure.
72
Removing and installing components
To Next Page
Loading...
