Steps
1. Remove the two screws (M2.5x5) that secure the right hinge in place to the palm-rest and keyboard assembly.
2. Lift the right hinge away from the palm-rest and keyboard assembly to access the power button with optional fingerprint
reader.
3. Peel back the tape holding the optional fingerprint-reader flexible printed circuit to the palm-rest and keyboard assembly.
4. Remove the screw (M2x2) that secures the power button with optional fingerprint reader to the palm-rest and keyboard
assembly.
5. Lift the power button with optional fingerprint reader off the slot on the palm-rest and keyboard assembly.
Installing the power button with optional fingerprint reader
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the power button with optional fingerprint reader and provide a visual
representation of the installation procedure.
Removing and installing components
77
To Next Page
Loading...
