NOTE: When replacing the 4-cell battery, use a plastic scribe to push downward into the bottom-left screw hole to
insert the battery rubber stopper into the slot on the new replacement 4-cell battery.
2. Connect the battery cable to the 4-cell battery.
3. Place the 4-cell battery along with the battery cable on the palm-rest and keyboard assembly.
4. Align the screw holes on the 4-cell battery to the screw holes on the palm-rest and keyboard assembly.
5. Replace the four screws (M2x3) to secure the 4-cell battery to the palm-rest and keyboard assembly.
Next steps
1. Install the base cover.
2. Install the secure digital card.
3. Follow the procedure in After working inside your computer.
Memory module
Removing the memory module
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the secure digital card.
3. Remove the base cover.
About this task
The following images indicate the location of the memory module and provide a visual representation of the removal procedure.
Removing and installing components
23
To Next Page
Loading...
