Steps
1. Place the power button with optional fingerprint reader into its slot on the palm-rest and keyboard assembly.
2. Align the screw hole on the power button with optional fingerprint reader to the screw hole on the palm-rest and keyboard
assembly.
3. Replace the screw (M2x2) to secure the power button with optional fingerprint reader to the palm-rest and keyboard
assembly.
4. Adhere the tape to secure the optional fingerprint-reader flexible printed circuit to the palm-rest and keyboard assembly.
5. Close the right hinge towards the power button with optional fingerprint reader on the palm-rest and keyboard assembly.
6. Replace the two screws (M2.5x5) to secure the right hinge in place to the palm-rest and keyboard assembly.
Next steps
1. Install the I/O daughter-board.
2. Install the display assembly.
3. Install the wireless card.
4. Install the base cover.
5. Install the secure digital card.
6. Follow the procedure in After working inside your computer.
Power-adapter port
Removing the power-adapter port
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the secure digital card.
3. Remove the base cover.
4. Remove the wireless card.
5. Remove the display assembly.
78
Removing and installing components
To Next Page
Loading...
