2. Lift and remove the left hinge from the display assembly.
3. Remove the three screws (M2.5x3.8) that secure the right hinge to the display panel and back cover.
4. Lift and remove the right hinge from the display assembly.
Installing the display hinges
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the display hinges and provide a visual representation of the installation procedure.
Steps
1. Align and place the left hinge on the display assembly.
2. Replace the three screws (M2.5x3.8) to secure the left hinge to the display panel and back cover.
3. Align and place the right hinge on the display assembly.
4. Replace the three screws (M2.5x3.8) to secure the right hinge to the display panel and back cover.
Removing and installing components
53
To Next Page
Loading...
