Steps
Place the display back-cover and antenna assembly on a flat surface and perform the post-requisites to install the display
back-cover and antenna assembly.
Next steps
1. Install the display cable.
2. Install the camera.
3. Install the display panel.
4. Install the display hinges.
5. Install the display bezel.
6. Install the display hinge caps.
7. Install the display assembly.
8. Install the wireless card.
9. Install the base cover.
10. Install the secure digital card.
11. Follow the procedure in After working inside your computer.
Palm-rest and keyboard assembly
Removing the palm-rest and keyboard assembly
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the secure digital card.
3. Remove the base cover.
4. Remove the memory module.
5. Remove the M.2 2230 solid-state drive or the M.2 2280 solid-state drive, whichever applicable.
NOTE: This procedure applies only to systems shipped with a M.2 solid-state drive installed.
82 Removing and installing components
To Next Page
Loading...
