3. Replace the screw (M2x2) and the three screws (M2x3.5) to secure the system board to the palm-rest and keyboard
assembly.
4. Connect the following cables to the system board:
a. I/O daughter-board FFC
b. Power-adapter port cable
c. Keyboard FFC
d. Keyboard-backlight FFC, if applicable
NOTE: This step applies only to systems shipped with a keyboard backlight installed.
e. Touchpad FFC
f. Hard-disk drive FFC, if applicable
NOTE: This step applies only to systems shipped with a 2.5-inch hard-disk drive installed.
Next steps
1. Install the display assembly.
2. Install the system board thermal plate, if applicable.
3. Install the wireless card.
4. Install the M.2 2230 solid-state drive or the M.2 2280 solid-state drive, whichever applicable.
NOTE: This procedure applies only to systems shipped with a M.2 solid-state drive installed.
5. Install the memory module.
6. Install the base cover.
7. Install the secure digital card.
8. Follow the procedure in After working inside your computer.
I/O daughter-board flexible flat cable
Removing the I/O daughter-board flexible flat cable
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the secure digital card.
70
Removing and installing components
To Next Page
Loading...
